
BLAIRS fringe sponsor Pump is a hardware to accomplish the correct water pressure in a little homegrown application. The programmed pressure frameworks are intended to consequently begin and stop the siphon on opening and shutting of taps. siphons can offer elite, devouring low force, dependable, prudent, and easy to utilize which have especially consistent working bends. For the right working of the siphon, utilize clean water. Siphon is combined with a Compact planned formed siphon, a manometer, a Pressure stomach tank, a pressing factor flexible switch, and a 3 or 5 different ways association in stepped metal. These siphons ought to be introduced in a covered territory, secured against the weather.
BLAIRS fringe sponsor Pump AUTO SPIN is combined with an ELECTRONIC FLOW SWITCH It makes the electric siphon start when distinguishing a base liquid dropping development into the line. AUTO SPIN Pumps closure appropriately inside when the stream has been intruded on (taps shutting or no water on pull side) from 10 to 180 seconds. It secures against the dry running, standard stretch 60 min/4 endeavors. No need of maintenance.
APPLICATION
BLAIRS fringe sponsor’s siphons are especially reasonable for homegrown applications and for programmed dissemination of water from flood tanks, watering gardens and to boosting the lacking water pressure supply from wells, homegrown Storage tanks, To lifting water and conveyance in homegrown fittings to expand the pressing factor in reservoir conduits & programmed water appropriation by little and medium estimated Pressure tanks or by hydrosphere units.
PERFORMANCE RANGE Flow rate up to 50 I/min.(3.0m3/h)
Head up to 60 m
OPERATING LIMITS Suction lift up to 8 m
Fluid temperature up to 60°C
Maximum encompassing temperature 40°C
STRUCTURAL CHARACTERISTICS Pump body Cast Iron
Motor Support Cast Iron
Impeller Brass
Shaft with rotor Stainless Steel
Mechanical seal Carbon/Ceramic
MOTOR
Built-in over-burden engine defender with programmed reset
Permanent split capacitor
Protection IP 44
Pump Model | Power | Qm3/h | 0 | 0.3 | 0.6 | 1 | 1.2 | 1.5 | 1.8 | 2.1 | 2.4 | 3.0 | |
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Single Phase | KW | HP | 1/min | 0 | 5 | 10 | 15 | 20 | 25 | 30 | 35 | 40 | 50 |
PBP 60 | 0.37 | 0.6 | H (m) | 40 | 38 | 33.5 | 29 | 27 | 19.5 | 15 | 10 | 5 | |
PBP 80 | 0.8 | 0.8 | 70 | 66 | 61 | 56 | 41 | 46 | 41 | 36 | 31 | 22 |
H= Total Head in Meters.
Q= Flow Rate